Description

The number 1 gooseneck hitch in America! The Turnover Ball installs completely under the pickup bed, requiring only a 4 inch hole for the ball to pass through. Installation requires no welding or bed removal, and uses only existing holes in the frame with few exceptions.

• BW-4085 Extender is the only accessory that may be used and is recommended on 4 dr. short bed models.
• See "Vehicle" tab for the complete list of vehicles that this hitch is designed to fit.
• For more turning clearance use BW Extender - BW-4085
• Please note: This kit is only designed to fit the DT frames with a gas engine without air suspension
• Excludes Ram 1500 Classic models
• Will not fit TRX models
• This kit is not made to install directly into a truck with air suspension without custom modification. If you still choose to install the kit into your truck,
  PLEASE READ THE FOLLOWING -

  NOTICE:

  If your truck has a four−corner air suspension, extra steps are required before installing the front cross member. An air line and a wiring harness running along the inside of the passenger side frame will need to be disconnected, pulled away from the frame and rerouted along the top of the frame. Push the air lines and wires to the outside of the frame so they lay along the vertical flange of the truck bed. There are also air lines on the driver side of the frame that will need to be loosened and pushed up over the frame so that there is space to place the end of the front cross member over the frame. Do not damage the rigid air components protruding from the top of the air bags when moving the front cross member into place.

  NOTICE:

  If your truck has four−corner air suspension, when the passenger side plate is installed, the air line and wiring harness should transition from the inside of the frame to the top in front of the side plate. These lines should continue around the hitch components on top of the frame toward the outside of the frame.